Forums » Suggestions

The Official Roll-Specific Ship Design & Suggestion Thread

«12
Mar 21, 2007 toshiro link
It will take you much longer at first... but it'll take you less time afterwards, if you want to make a quick change. Trust me, I've been there before.

Or don't, I said what I wanted to say.
Mar 21, 2007 moldyman link


Spring Roll

Cruising Speed: 0.3 m/s
Turbo Speed: 1 m/s
Turbo Drain: 0.1 m/s
Spin Torque: 0.1Nm
Mass: 0.3 kg
Length: 0.12m
Weapons: None
Cargo: 1 cu
Special Notes: This Spring Roll is yummy and scrumcious. It can come deep fried, pan fried or boiled. Warning, may impose a penalty of 1 m/s due to heartburn.
Mar 21, 2007 Jim Kirk link
Ok, you killed it dead moldy...
Mar 22, 2007 moldyman link
Yup! ^_^
Mar 22, 2007 genka link

California roll!
Yummy, cheap and stuck up!
Mar 22, 2007 Dr. Lecter link
Damnit, Genka...
Mar 22, 2007 Jim Kirk link
Damn it.
Mar 22, 2007 Zed1985 link
On a slightly more serious note.

Cunjo's ships seem to be a tad too big compared to what we have now. I think it would be cool if a new class of ships was introduced.

So say these could be Corvettes. Then we can replace the "Combat levels" by "Fighter Level" then add "Corvette levels" and "Capital"... and Super Capital etc... But then again I am pretty sure this has been suggested millions of times...?
Mar 22, 2007 Cunjo link
They're both technically smaller than the moth :P

Though I think the Reaver needs to be bigger... because it should be almost as big as the moth, if not bigger (wider). Right now it's about the same as the taur....

Now, the Falcon may have some difficulty entering a docking bay face-forward, but I'm sure there are ways around that... for one, it would likely be intended for deployment from a hanging mooring rather than a flat bay, and could be carried into battle by capships, etc... anyway, plenty of posibilities. For now though, it might need a pinch to fit into docking bays without flipping on its back....
Mar 25, 2007 Jim Kirk link
Mine's very tiny.
Mar 25, 2007 Cunjo link
"It will take you much longer at first... but it'll take you less time afterwards, if you want to make a quick change. Trust me, I've been there before."

Trust me, it's not worth it in my case.
Mar 26, 2007 toshiro link
If you say so...
Mar 26, 2007 Jim Kirk link
Well, I guess I'll repost mine...